HP ProLiant DL320e Gen8 v2 - Page 53

Hardware options installation 53
6.
Install the TPM board. Press down on the connector to seat the board ("System board components" on
page 9).
7. Install the TPM security rivet by pressing the rivet firmly into the system board.
8. If removed, install the PCI riser cage (on page 20).
9. Install the access panel (on page 17).
10. Do one of the following:
o Slide the server into the rack.
o Install the server into the rack ("Installing the server into the rack" on page 26).
11. Connect the peripheral devices to the server.
12. Connect the power cord to the server.
13. Connect the power cord to the power source.
14. Power up the server (on page 14).