Enable SATA RAID
NOTE: This option is available only on server models that support Dynamic Smart Array. For
more information, see the HP Dynamic Smart Array RAID Controller User Guide on the HP website
at http://www.hp.com/support/DSA_RAID_UG_en.
This option allows the user to configure the embedded chipset serial ATA (SATA) controller to one
of three operational modes.
IMPORTANT:
• Changing this setting may result in data loss or data corruption on existing drives.
• Back up all drives before changing this setting.
• Enable AHCI SATA support only after consulting the OS documentation to ensure that base
media drivers support this feature.
When this option is selected, the following warning is displayed:
After pressing any key to clear the warning, the following options are displayed:
• Legacy SATA
• AHCI SATA
• HP SATA RAID
NOTE: The default setting for this option is dependent on the server model.
38 RBSU menu-driven interface (G7 and later servers)
To Next Page
Loading...
