HP ProLiant DL380 Gen9 Server - Install the PCI Riser Cage

Operations 29
1.
Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 24).
o Remove the server from the rack (on page 25).
4. Remove the access panel (on page 25).
5. Remove the PCI riser cage.
Install the PCI riser cage
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 24).
o Remove the server from the rack (on page 25).
4. Remove the access panel (on page 25).