Hardware options installation 53
Universal media bay option
The following procedure provides the steps to install the universal media bay option, route the VGA and USB
cables, and install an optional optical disk drive. The universal media bay option also accommodates the
two-bay SFF front drive cage option. For information on installing this option, see "Two-bay SFF front drive
cage option (on page 77)."
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 24).
o Remove the server from the rack (on page 25).
4. Remove the access panel (on page 25).
5. Remove the air baffle (on page 31).
6. Remove the fan cage (on page 27).
7. Remove the bay blank.
To Next Page
Loading...
