Operations 30
5.
Install the PCI riser cage.
6. Install the access panel (on page 26).
7. Install the server into the rack ("Installing the server into the rack" on page 36).
8. Connect each power cord to the server.
9. Connect each power cord to the power source.
10. Power up the server (on page 24).
Secure the full-length expansion board retainer
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 24).
4. Remove the access panel (on page 25).
5. Install a full-length expansion board ("Installing an expansion board" on page 58).
6. Install the PCI riser cage (on page 29).
To Next Page
Loading...
