Hardware options installation 93
o
Connected to an HP 12G SAS Expander Card
11. Install the access panel (on page 26).
12. Slide the server into the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server (on page 24).
Systems Insight Display power switch module option
This option is not supported in servers configured with 4 LFF or 12 LFF drives.
To install the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 24).
o Remove the server from the rack (on page 25).
4. Remove the access panel (on page 25).
5. Remove the air baffle.
To Next Page
Loading...
