Hardware options installation 73
o
Connected to an HP 12G SAS Expander Card
10. Install the fan cage.
11. Install the access panel (on page 26).
12. Slide the server into the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server (on page 24).
Eight-bay SFF front drive cage option for bay 2
To install the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
To Next Page
Loading...
