Hardware options installation 52
3.
Install the drive.
4. Determine the status of the drive from the drive LED definitions ("Hot-plug drive LED definitions" on page
21).
Removing a hot-plug SAS or SATA drive
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug SAS drive LED combinations ("Hot-plug drive LED
definitions" on page 21).
2. Back up all server data on the drive.
3. Remove the drive.
To Next Page
Loading...
