Removal and replacement procedures 65
7.
Disconnect the cable, and then remove the Smart Storage Battery.
To replace the component, reverse the removal procedure.
HPE Flexible Smart Array Controller
CAUTION: Hewlett Packard Enterprise recommends performing a complete backup of all
server data before performing a controller or adapter installation or removal.
To remove the component:
1. Power down the server (on page 27).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 27).
o Remove the server from the rack (on page 28).
4. Remove the access panel ("Access panel" on page 32).
5. Remove the air baffle.
6. Disconnect the SAS cables.
To Next Page
Loading...
