To edit management settings on the SNMP Settings tab:
1. In the iLO Configuration Utility window, click Management.
The SNMP Settings tab data appears:
2. Click Agentless Management or SNMP Pass-Thru.
3. Enter data in the fields as necessary. Click Apply.
Management — SNMP Alerts
• Trap Source Identifier—This setting determines the host name that is used in the SNMP-defined
sysName variable when iLO generates SNMP traps. The default setting is iLO Hostname.
• iLO SNMP Alerts—Alert conditions that iLO detects independently of the host OS can be sent
to specified SNMP alert destinations, such as HP SIM.
• Forward Insight Management Agent SNMP Alerts—Alert conditions detected by the host
management agents can be forwarded to SNMP alert destinations through iLO. These alerts
are generated by the Insight Management Agents, which are available for each supported
OS. Insight Management Agents must be installed on the host server to receive these alerts.
• Cold Start Trap Broadcast—Cold Start Trap is broadcast to a subnet broadcast address if there
are no trap destinations configured in the SNMP Alert Destination(s) boxes. The subnet
broadcast address for an IPv4 host is obtained by performing a bitwise logical OR operation
between the bit complement of the subnet mask and the host IP address. For example, the host
192.168.1.1, which has the subnet mask 255.255.252.0, has the broadcast address
192.168.1.1 | 0.0.3.255 = 192.168.3.255.
• SNMPv1 Traps—When enabled, SNMPv1 traps are sent to the remote management systems
configured in the SNMP Alert Destination(s) boxes.
To edit the settings on the SNMP Alerts tab:
1. In the iLO Configuration Utility window, click Management. The SNMP Settings tab data
appears.
2. Click the SNMP Alerts tab.
The SNMP Alerts data appears.
56 Performing maintenance
To Next Page
Loading...
