Hardware options installation 42
13. Connect all the drive cables.
14. Install the system air baffle (on page 24).
15. If removed, install the PCI air baffle ("Install the PCI air baffle" on page 22).
16. Install the front bezel (on page 21).
17. Install the access panel (on page 19).
18. Return the server to an upright position.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Power up the server (on page 18).
Installing a hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To install the component:
1. Remove the drive blank.
To Next Page
Loading...
