Hardware options installation 43
2. Prepare the drive.
3. Install the drive.
4. Determine the status of the drive from the drive LED definitions.
To configure arrays, see the HP Smart Storage Administrator User Guide on the HP website
(http://www.hp.com/go/smartstorage/docs).
Drive cable options
Use these drive cable options to install an HP Host Bus Adapter or an HP Smart Array Controller board
option.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
Host Bus Adapter Mini-SAS cable option
To install the component:
1. Power down the server (on page 18).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Place the server on its side.
4. Remove the access panel (on page 18).
5. If installed, remove the PCI air baffle (on page 22).
To Next Page
Loading...
