Hardware options installation 54
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Place the server on its side.
4. Remove the access panel (on page 18).
5. If installed, remove the PCI air baffle (on page 22).
6. Remove the system air baffle (on page 23).
7. Remove the slot covers.
8. Install the HP Smart Storage Battery holders.
9. Install the system air baffle (on page 24).
10. If removed, install the PCI air baffle ("Install the PCI air baffle" on page 22).
11. Install the access panel (on page 19).
12. Return the server to an upright position.
To Next Page
Loading...
