HP ProLiant ML150 G6 - SAS;SATA Hot-Plug Hard Drive Leds

Diagnostic Tools and Setup Utilities 100
SAS/SATA Hot-Plug Hard Drive LEDs
The SAS and SATA hot-plug hard drive LEDs are located on each physical drive and visible when the
front bezel is open.
• Activity LED—This green LED indicates the disk drive access activity. This LED is controlled by the
disk drive d i r ect ly. When a driv e i s accessed, the LE D shows a green light
• Status LED—This amber/blue LED indicat es th e d r iv e operating condition: norm al, warning, or
failure.
Table 5–3 describes the LEDs signals used to indicate the operating status of a SAS or SATA disk
drive.
Table
5
-5 Carrier status light definitions
Activity
(green)
Status
(amber/blue)
Description
No power, offline or not configured
Normal operation under power. no activity [green is on-solid]
Normal operation under power, disk activity [green is fluttering]
Offline, disk not being accessed, predictive failure [amber is flashing at
constant 1 Hz]
Online, no activity, predictive failure (further investigation required) [green is
fluttering, amber is flashing at constant 1 Hz]
Disk activity, predictive failure (further investigation required) [green is
fluttering, amber is flashing at constant 1 Hz]
Offline, no activity, critical fault condition [amber is on-solid]
Offline, drive selected (blue reserved for identification only) [blue is on steady]
Drive rebuilding [green is flashing at constant 1 Hz]
All manuals and user guides at all-guides.com