Removal and replacement procedures 67
Replacing the system board
To replace the system board, proceed as follows:
1. Lower the system board int o the chassis, tilting the rear edge down first so that the rear port
connectors align with the rear panel cutouts, then lower the front edge down until it is level.
Ensure that the mounting holes on the board are aligned with the screw taps on the chassis.
2. Insert and tighten the 11 mounting screws.
3. Install the processor heatsink(s) as described in the section “Replacing the processor.”
4. Install the system fans as described in the section “System fans.”
5. Install any expansion cards as described in the sect i on “Installing an expansion card.”
6. Return the server to an upright position.
7. Replace the access panel.
8. Connect the power supply cord(s).
End of procedure.
To Next Page
Loading...
