Removal and replacement procedures 29
To reinstall the acc ess panel:
1. Use both han ds to place the access panel flat aga i n st the chassis, th e back of the access p anel
extending about 1.3 cm (0.5 in) behind t he back of the server . Make sure the stand-off on the
access panel align with the holes on the edges of the chassis.
2. Slide the panel toward the front of the chassis to position it into place.
3. Tighten the captive thumbscrews to secure the panel.
Figure 3-2 Reinstalling the access panel
End of procedure.
Front bezel
To open or remove t he front bezel:
1. If necessary, unlock th e front bezel door using the supplied key.
2. Open the bezel door to the right and lift up to remove it.
Figure 3-3 Opening the front bezel
To Next Page
Loading...
