Diagnostic Tools and Setup Utilities 73
Accessing the BIOS Setup Utility
To access the BIOS Setup Utility, perform the following steps:
1. Turn on the monitor and server. If the server is already turned on, save your data and exit all
open applications, then restart the server.
2. When the HP logo is displayed during POST, press F10. After a few moments, the Main menu
will be displayed ( Figure 4-1). NOTE: If you fail to pre ss F10 befor e POS T is comp leted, y ou will
need to restart the server.
Figure 4-1 Main menu of the BIOS Setup Utility
Navigating through the Setup Utility
Table 4-1 lists and describes the keys used for navigating through the Setup Utility menus and
selecting and changing parameters. Pressing F1 from the Main menu displays a pop-up menu that
also displays most of t h e navigation keys and their functions.
To Next Page
Loading...
