Removal and replacement procedures 35
6. Using the provided surplus screws, install f our screws.
7. Release the drive latch lever (Figure 3-8, 1).
8. Slide the new drive into the bay until it stops (Figure 3-8, 2).
Figure 3-8 Installing an optical drive
9. Connect the power and data cables to the connectors on the rear of the new drive.
10. Replace the f ront bezel and access panel.
11. Reconnect the power cord(s).
End of procedure.
To remove an optical or tape drive, reverse the procedure above.
To Next Page
Loading...
