Removal and replacement procedures 39
3. If replacing a hot-plug drive, remove the hot-plug drive to be replaced:
a. Push in the thumb release of th e desired hard drive carrier (Figure 3-13, 1).
b. Pull the cam latch upward (Figure 3-13, 2).
c. Gently pull the hard drive carrier straight out from the drive bay (Figure 3-13, 3).
Figure 3-13 Removing a hot-plug hard drive
4. Slide the hot-plug HDD drive into the drive bay until resistance is felt (Figure 3-14, 1).
5. Verify that the hooks behind the pivot end of the cam latch will engage the h ol e on the edge of
the hard drive cage.
6. Rotate the cam latch down to fully seat the drive carrier into the backplane and press in until it
clicks into place (Figure 3-14, 2).
Figure 3-14 Installing a hot-plug hard drive
7. Replace and close the front bezel.
End of procedure.
To Next Page
Loading...
