Removal and replacement procedures 41
6. Remove the four mounting screw s from the HDD cage (Figure 3-16, 1) and slide the HDD cage
out from the server chassis (Figure 3-16, 2).
Figure 3-16 Removing a hot-plug HDD cage
7. To remove and replace the backplane:
a. Remove the two screws securing the backplane to the HDD cage (Figure 3-17, 1).
b. Slide the backplane up slightly to clear the four cage hooks and securing post and then lift
the backplane away from the cage (Figure 3-17, 2).
Figure 3-17 Removing the backplane from the HDD cage
c. To replace the backpl ane, reverse steps a and b.
End of procedure.
To replace the hot-plug HDD cage, reverse steps 1 through 6.
To Next Page
Loading...
