Removal and replacement procedures 55
To install a memory module:
1. Completely open the holdi n g clip s.
2. Orient the module so that the notch on the bottom edge of the module aligns with the keyed
surface of the DIMM slot, and then press it fully into the slot (Figure 3-33, 1).
3. Firmly press th e hol d in g clips inward to secure the memory module in place (Figure 3-33, 2).
Figure 3-33 Installing a memory module (DIMM)
CAUTION: The memory slots are structured to ensure prop er i n stallation. If a memory module do es
not fit easily into the slot, it may be inserted incorrectly. Double-check the orientation of the module
and reinsert. If the holding clips do not close comp letely, the module is not inserted correctly.
End of procedure.
To Next Page
Loading...
