-2 POST Error Messages
Error Code Error Message Description/Corrective Action
503h Redundant Power Supply
#1 Failure
Redundant Power Supply #1 fails. Replace Redundant
Power Supply #1.
504h Redundant Power Supply
#2 Failure
Redundant Power Supply #2 fails. Replace Redundant
Power Supply #2.
510h BMC SEL Is Full BMC SEL is full.
601h BMC not responding BMC is not responding.
5100h Unsupported Processor The processor is not support ed.
Multi-Bit ECC Memory
Error
This message will only occur on systems using EC C
enabled memory modules. ECC memory has the ability
to correct single-bit errors that may occur from faulty
memory modules.
A multiple bit corruption of memory has occurred, and
the ECC memory algorithm cannot correct it. This may
indicate a defective memory module.
Fan Failure
System fan failure. Uninstall fan.
S ystem currently defaulted
to typical configura tion
settings. P l ease run RBSU
to modify default settings.
CMOS is cleared or CMOS ch ecksum is inva l id.
FAN or In let ambient
sensor detect fa iled
System fan failure or Inlet ambient cable not present.
Pa rity E rror
Fatal Memory Parity Error. System halts after
displaying this message.
S.M.A.R.T. Status BAD,
Backup and Replace
A S.M.A.R.T. capable hard disk sends this message when
it detects an imminent failure.
This message can be reported by an ATAPI device using
the S.M.A.R.T. error reporting standard.
S.M.A.R.T. failure messages may indicate the need to
replace the hard disk.
S ystem Halted
The system has been halted. A reset or power cycle is
required to reboot the machine. This message appears
after a fatal error has been detected .
To Next Page
Loading...
