Removal and replacement procedures 34
b.
Pull the front USB module out of the server.
To replace the component, reverse the removal procedure.
DIMMs
To remove the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Power down the server (on page 23).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 24).
6. If installed, remove the PCI air baffle (on page 25).
7. Remove the system air baffle (on page 24).
8. Open the DIMM slot latches.
To Next Page
Loading...
