Removal and replacement procedures 42
11.
Remove the SFF drive cage.
To replace the component, reverse the removal procedure.
Four-bay LFF hot-plug drive cage
To remove the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Power down the server (on page 23).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Remove all drives ("Hot-plug drive" on page 27) and drive blanks ("Hot-plug drive blank" on page
27).
5. Place the server on its side.
6. Remove the access panel (on page 24).
7. If installed, remove the PCI air baffle (on page 25).
8. Remove the system air baffle (on page 24).
9. Remove the fans (on page 25).
10. Disconnect the Mini-SAS cable and the power cable from the drive cage backplane.
To Next Page
Loading...
