Removal and replacement procedures 43
11.
Remove the LFF hot-plug drive cage.
To replace the component, reverse the removal procedure.
Four-bay LFF non-hot-plug drive cage
To remove the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Power down the server (on page 23).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 24).
6. Remove the fans (on page 25).
7. Disconnect the drive cables from the rear of the drives.
To Next Page
Loading...
