HP ProLiant ML150 Gen9 - HPE 800 W;900 W Gold AC Power Input Module

Removal and replacement procedures 57
a.
Remove the power supply assembly from the server.
b. Remove the power supply from its tray.
To replace the component, reverse the removal procedure.
HPE 800 W/900 W Gold AC Power Input Module
To remove the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Power down the server (on page 23).
3. Access the product rear panel.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.