Removal and replacement procedures 27
o
Two-processor configuration
To replace the component, reverse the removal procedure.
Storage drive
Hot-plug drive blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Remove the drive blank.
To replace the LFF drive blank, slide the component into the bay until it clicks.
To replace the SFF drive blank, while pressing the release latch, slide the component into the bay until it
is fully seated.
Hot-plug drive
To Next Page
Loading...
