HP ProLiant ML150 Gen9 - Remove the PCI Air Baffle; Remove the Fans

Removal and replacement procedures 25
6.
Remove the system air baffle.
Remove the PCI air baffle
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Power down the server (on page 23).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 24).
6. Remove the PCI air baffle.
Remove the fans