HP ProLiant ML150 Gen9 - HPE H240 Smart Host Bus Adapter

Removal and replacement procedures 44
8.
Remove the drive cage.
9. Remove the non-hot-plug drives.
To replace the component, reverse the removal procedure.
HPE H240 Smart Host Bus Adapter
To remove the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 23).
2. Power down the server (on page 23).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 24).