HP ProLiant ML30 Gen9 - Powering up the Server; Replacing the Drives; Replacing a Hot-Plug Drive Blank

Powering up the server
Procedure
1. Connect each power cord to the server.
2. Connect each power cord to the power source.
3. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes from
amber to green.
Replacing the drives
Replacing a hot-plug drive blank
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Remove the bezel.
2. Remove the drive blank.
• Hot-plug LFF drive blank
Powering up the server 33