3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove all drives.
6. Remove the access panel.
7. Remove the air baffle.
8. Disconnect all cables connected to any installed drives.
9. Remove the drive cage.
10. Remove the drive backplane.
To replace the component, reverse the removal procedure.
Replacing a drive in the non-hot-plug drive cage
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and internal system components
to cool before touching them.
Replacing a drive in the non-hot-plug drive cage 37
To Next Page
Loading...
