Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove the access panel.
6. Remove the air baffle.
7. Disconnect the SATA cables from the enablement board and system board.
8. Remove the M.2 SSD enablement board.
To replace the component, reverse the removal procedure.
Replacing an M.2 SSD module
Prerequisites
A No.1 Phillips screwdriver is needed for the following procedure.
Replacing an M.2 SSD module 41
To Next Page
Loading...
