To replace the LFF drive blank, slide the component into the bay until it clicks into place.
• Hot-plug SFF drive blank
To replace the SFF drive blank, while pressing the release latch, slide the component into the bay until it is
fully seated..
Replacing a hot-plug drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Back up all server data.
2. Remove the drive blank.
3. Determine the status of the drive LEDs.
4. Remove the hot-plug drive.
34 Replacing a hot-plug drive
To Next Page
Loading...
