To replace the component, reverse the removal procedure.
Replacing a four-bay LFF hot-plug drive backplane assembly
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and internal system components
to cool before touching them.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove all drives.
6. Remove the access panel.
7. Remove the air baffle.
8. Disconnect all cables connected to any installed drives.
9. Remove the drive cage.
Replacing a four-bay LFF hot-plug drive backplane assembly 35
To Next Page
Loading...
