To replace the component, reverse the removal procedure.
Replacing a redundant power supply assembly
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and internal system components
to cool before touching them.
Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove the access panel.
6. Remove the air baffle.
7. Remove the power supply.
8. Disconnect all power supply cables from the system board, drive cages, and devices.
9. Remove the EMI shield.
56 Replacing a redundant power supply assembly
To Next Page
Loading...
