To replace the component, reverse the removal procedure.
Replacing a system board
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and internal system components
to cool before touching them.
CAUTION:
To avoid ESD damage, when removing electrostatic-sensitive components from the failed system board,
place the components on a static-dissipating work surface or inside separate antistatic bags.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal or replacement procedure. Improper grounding can cause
electrostatic discharge.
Procedure
1. Power down the server.
2. Disconnect the power cord from the power source and the server.
3. Remove the bezel.
4. Place the server on its side with the access panel facing up.
5. Remove the access panel.
6. Remove the air baffle.
7. Remove all expansion boards.
8. Remove all DIMMs.
9. Remove the front PCI fan.
10. Remove the system fan.
11. Remove the heatsink.
12. Remove the processor.
13. Disconnect all cables connected to the system board.
14. Remove the system board:
58 Replacing a system board
To Next Page
Loading...
