To Next Page

To Previous Page

Installation 15

WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:

• The leveling feet are extended to the floor.

• The full weight of the rack rests on the leveling feet.

• The stabilizing feet are attached to the rack if it is a single-rack installation.

• The racks are coupled together in multiple-rack installations.

• Only one component is extended at a time. A rack may become unstable if more than one

component is extended for any reason.

NOTE: If preparing the rails for integrated shipping, follow the same instructions as in

"Installing the UPS ("Installing the UPS as a tower" on page 26, "Installing the UPS in a rack"

on page 18)."

NOTE: Mounting hardware for square- and round-holed racks is included in the UPS kit.

1. Loosen the wing nuts or hex nuts, and then extend the brackets to the desired length.

Questions and Answers:

Need help?

Do you have a question about the HP R3000 and is the answer not in the manual?

HP R3000 Specifications

General