To Next Page

To Previous Page

Installation 25

CAUTION: Do not plug laser printers into the UPS output receptacles. The instantaneous

current drawn by this type of printer can overload the UPS.

Before connecting devices, verify that the UPS will not overload by checking that the ratings of the devices

do not exceed the UPS capacity. If the equipment rating is listed in amps, multiply the number of amps by

the selected output voltage to determine the VA.

After verifying that the UPS will not overload (depending on your model):

• Connect the device power cords to the output receptacles on the rear panel of the UPS.

-or-

• Connect devices to the output receptacles on the rear panel of the UPS using the IEC-to-IEC power

cords included with the UPS.

To provide additional receptacles:

• Plug a PDU into the PDU output receptacle. The PDU output receptacle is part of load segment 1 and

can be turned off and on using power management software (on page 51).

• Plug an extension bar into any IEC-320-C19 receptacle to yield eight additional IEC-320-C13

receptacles.

Connecting the UPS cord retention clips

NOTE: UPS appearance might vary depending on the specific unit installed.

Charging the UPS batteries

With the UPS in Standby mode, allow the batteries to charge before putting the UPS into service.

Questions and Answers:

Need help?

Do you have a question about the HP R3000 and is the answer not in the manual?

HP R3000 Specifications

General