HP R5000 User Manual

Installation and configuration 29
3. Install the mounting ears on the chassis using the screws provided.
4. With one person on each side, lift the chassis to rail level and slide the chassis on the mounting rails. Be
sure that the cleat brackets slide into the channels on the rear stabilization brackets.
5. Attach the chassis to the rack using the supplied screws.
Attaching the ERM front bezel

HP R5000 Specifications

General

Output Voltage	230V
Form Factor	Rack-mountable
Rack Height	3U
Nominal Output Voltage	230V
Topology	Double Conversion Online
Input Voltage	230V
Frequency	50/60 Hz
Battery Recharge Time	3 hours
Transfer Time	0 ms
Operating Temperature	0 - 40 °C
Battery Type	Sealed Lead Acid (SLA)
Interface	USB, Serial
Output Power Capacity	4500 Watts
Efficiency	95%
Power Capacity	5000 VA
Dimensions	43.2 x 66 x 13 cm