● Select Automatic (DHCP) to have the settings automatically detected.
4. Select Confirm to confirm the change to the settings.
5. After changing the settings, select Close to close the confirmation message.
NOTE: The current IP settings are shown under IPv4 Address in the Network Configuration
section.
Configure the DNS Server Assignment
Follow this procedure to configure the DNS Server Assignment.
1. On the left side of the dashboard, select RSC Settings.
2. In the Network Configuration section, under DNS Server Assignment, select Edit.
3. Do one of the following:
● Select Manual from the drop-down menu to manually type the following values:
– Preferred DNS
– Alternate DNS
● Select Automatic (DHCP) to have the settings automatically detected.
4. Select Confirm to confirm the change to the settings.
5. After changing the settings, select Close to close the confirmation message.
NOTE: A list of DNS servers is displayed under Edit.
Configure the Proxy settings
Follow this procedure to configure the Proxy settings.
1. On the left side of the dashboard, select RSC Settings.
2. In the Network Configuration section, under Proxy, select Edit.
3. By default, the proxy server is disabled. Select the Disabled toggle to enable the proxy server.
4. Type the address for the proxy server to access, for example,
https://yourproxyserver.domain:8088.
5. If you have any addresses that need to be accessed without proxy, enter the addresses, separating
them by a semicolon (;), for example, 10.10.10.254;192.34.154.13.
6. Select Confirm to implement the updates.
7. After changing the settings, select Close to close the confirmation message.
Configure KVM
Follow this procedure to configure the KVM settings.
Configure the DNS Server Assignment
9
To Next Page
Loading...
