SpecificationsA
This section contains technical specifications for the physical aspects of your product, such as the
weight and dimensions, as well as required environmental operating conditions and power source
ranges.
Input power
The power information in this section can be helpful if you plan to travel internationally with the HP
Remote System Controller.
NOTE: The AC power source must be rated at 100 - 240 V, 50/60 Hz. Although the Remote System
Controller can be powered from a standalone AC power source, it should be powered only with the AC
adapter that is supplied and approved by HP for use with the HP Remote System Controller, or by DC
power from the remote host.
The HP Remote System Controller operates with the AC power adapter within the following
specifications.
Table A-1
Input power ratings
Input Power Rating
Operating voltage and current 40 W; Input 100–240 V 1.2 A, 50/60 Hz. Output is 12.0 V at
3.33 A.
NOTE: This product is designed for IT power systems in Norway with phase-to-phase voltage not to
exceed 240 V rms.
NOTE: You can find the HP Remote System Controller operating voltage and current on the regulatory
label on the device.
Operating environment
This section provides information about the recommended operating environment for the HP Remote
System Controller.
Table A-2
Operating environment specifications
Factor Metric U.S.
Temperature
Operating 0°C to 40°C with AC adapter, 0°C to 50°C
without AC adapter
32°F to 104°F with AC adapter, 32°F to
122°F without AC adapter
Nonoperating –40°C to 60°C –40°F to 140°F
Relative humidity (noncondensing)
Operating 10% to 90% 10% to 90%
22 Appendix A Specifications
To Next Page
Loading...
