HP Remote System Controller - Configuring the Access Security; Configure the Password

1. On the left side of the dashboard, select RSC Settings.
2. In the KVM Configuration section, the following settings are available:
● Enable HP vDisplay Only During KVM Session
When this feature is enabled, the RSC's virtual monitor is available only to the remote host
while there is an active KVM session. If this feature is disabled, the virtual monitor is always
available to the remote host.
● Enable Collaboration During KVM Session
Enabling this feature allows more than one user to access the KVM session at the same time. If
this feature is disabled, only one user can access the KVM session. If a new user joins the KVM
session, the previous user is removed from it.
● Collaboration requires authorization
This setting is available only if the Collaboration setting is enabled. When the setting is enabled,
every time a collaborator joins a KVM session, an authorization request is displayed to the main
user (the first user in the session). The main user can then allow or deny the collaboration
request. If this setting is disabled, all collaboration requests are automatically accepted.
● Port Range
This feature allows the user to select which port range is used by the KVM agent running inside
RSC when a new KVM connection is attempted. The default values are 3478 to 3481.
Configuring the access security
Use this information to configure the Remote System Controller for the optimum web server and API
access security.
● Use a strong password. See Configure the password on page 10.
● Install a trusted certificate
Configure the password
Use this information to configure the password.
1. On the left side of the dashboard, select RSC Settings.
2. In the Passwords section, click Change. Type the new information in the Old password, New
password, and Confirm new password fields.
NOTE: You cannot use a password that has already been used as one of the last 24 passwords you
created.
● Use a minimum of 12 characters
● Make sure that the password contains at least three of the following:
– Lowercase character
– Uppercase character
10
Chapter 2 Configuring the HP Remote System Controller