Adjusting BIOS settings
Follow this procedure to adjust BIOS settings.
1. Select a tab to view and adjust settings.
2. Navigate through the available options and adjust settings as needed.
3. Select Apply Changes. A dialog box opens with the following options:
● Apply Now and Reboot: Immediately applies the changes and restarts your system.
● Apply on Next Reboot: Changes are applied the next time you restart your system.
● Cancel: No changes are applied, and you are returned to the previous screen.
IMPORTANT:
● Changes in BIOS settings are not applied until you choose to apply them. Be sure to select the
correct option in configuration modal.
● Incorrect BIOS configurations can affect system stability. If you are uncertain, use the default
settings or consult support documentation.
Booting to the virtual media drive
Use this procedure to boot to the virtual media drive in HP Remote System Controller.
The Virtual Media drive is attached through USB to the host workstation.
■
To enable booting from the Virtual Media drive, perform either of the following procedures:
● In the BIOS boot menu, select the USB boot option.
● Change the boot order BIOS configuration so that the USB option is located at the top.
20
Chapter 3 Accessing and controlling the remote host
To Next Page
Loading...
