NOTE:
• NICs will display with a failed status (red icon) if they are unplugged. To remove unused
NICs from the system status, you can disable them by selecting Control
Panel→Hardware→Device Manager, right-click on the specific NIC, and then select Disable.
• When you remove a disk or disconnect a cable, the SMH interface might not display alerts
when you click the Refresh button. You can force a hard refresh by clicking the Home button
or by navigating to the problem area. The default refresh interval is two minutes. To change
the interval in the Settings menu, select Autorefresh, and then Configure Page refresh
settings. The minimum interval is five seconds and the maximum is 30 minutes.
Overall System Health Status
A webapp sets the value of the Overall System Health Status icon by using a predefined
heuristic. If no webapp can determine the status, the worst possible status is displayed in the
Component Status Summary section.
Component Status summary
The Component Status Summary section displays links to all subsystems that have a critical,
major, minor, or warning status. If there are no critical, major, minor or warning items, the
Component Status Summary section displays no items.
Network
This section shows the status of the network connections.
Storage
This section displays information about the Smart Array and storage controllers within HPE
StoreEasy 1000 Storage. The Storage System page is organized as a left panel and a main
page:
Figure 59 Storage system
152 Troubleshooting, servicing, and maintenance
To Next Page
Loading...
