Table 1 Systems Insight Display LEDs and internal health LED combinations (continued)
StatusSystem power
LED
Health LEDSystems Insight
Display LED and
color
One or more DIMMs have failed.GreenRedDIMM (amber)
DIMM in slot X is in a pre-failure condition.GreenAmber
The Health Driver has detected a cautionary
temperature level.
GreenAmberOver temp
(amber)
The server has detected a hardware critical temperature
level.
AmberRed
The PCI riser cage is not seated properly.GreenRedPCI riser (amber)
One fan has failed or is removed.GreenAmberFan (amber)
Two or more fans have failed or are removed.GreenRed
One or more of the following conditions may exist:AmberRedPower supply
(amber)
• Only one power supply is installed and that power
supply is in standby.
• Power supply fault.
• System board fault.
One or more of the following conditions may exist:GreenAmber
• Redundant power supply is installed and only one
power supply is functional.
• AC power cord is not plugged into redundant power
supply.
• Redundant power supply fault.
• Power supply mismatch at POST or power supply
mismatch through hot-plug addition.
StandbyAmber—Power cap (off)
Waiting for powerFlashing green—Power cap (green)
Power is availableGreen—
NOTE: For more information on troubleshooting, refer to the hardware platform information.
The following list identifies the ProLiant model for each HPE StoreEasy 1000 Storage product:
• 1450—ProLiant DL160 Gen9 server
• 1550—ProLiant ML110 Gen9 server
• 1650—ProLiant DL380 Gen9 server
• 1650 Expanded—Apollo 4200 Gen9 server
• 1850—ProLiant DL380 Gen9 server
The ProLiant documentation is available at:
http://www.hpe.com/support/proliantgen9/docs
Installing an M.2 SSD Enablement Board in the StoreEasy 1650 Expanded
Storage System
1. Power down the server.
Installing an M.2 SSD Enablement Board in the StoreEasy 1650 Expanded Storage System 27
To Next Page
Loading...
