Validate network information
Complete the tests in Table 3 (page 36) to verify network connectivity. Consult with your network
administrator to confirm test results.
Table 3 Validation tests
Successful?
(Y/N)Command(s) to executeTest
ping <system address>Ping the IP address of the system
from another system on the same
network.
ping <system address>Ping the IP address of some other
system on the same network form
the system.
ping <node 1 name>
ping <node 1 fqdn>
Ping the name of the system from
another system on the same
network.
ping <node 1 name>
ping <node 1 fqdn>
Ping the name of some other
system on the same network form
the system.
If you will be adding the system to an Active Directory domain, some additional tests include:
ping <domain controller address>
ping <domain controller name>
Ping the domain controller from the
system.
pathping <domain controller address>
pathping <domain controller name>
Verify the network path to the
domain controller and DNS servers
is correct.
pathping <DNS server address> (Repeat for each
DNS server)
pathping <DNS server name> (Repeat for each DNS
server)
Additionally, HPE recommends that you also verify the iLO IP address and name resolution.
However, this is not critical to support a file server.
Cabling HPE StoreEasy 1000 Storage
The StoreEasy systems support both single domain and dual domain cabling using D2000,
D3000, D6020, and D6000 disk enclosures, depending on the Smart Array RAID controller that
is installed in the system. See Table 4 (page 36) for details. In a single domain, external disk
enclosures are connected, using a single data path, to the Smart Array controller
1
in the StoreEasy
system. In a dual domain, external disk enclosures are connected, using two data paths, to a
single Smart Array RAID controller in the StoreEasy system. For more detailed information about
single and dual domains, see the technology brief entitled, “Redundancy in enterprise storage
networks using dual-domain SAS configurations” located at: http://h20565.www2.hp.com/portal/
site/hpsc/public/kb/docDisplay/?docId=c01451157.
Table 4 Controller, disk enclosure, and single/dual domain support
Dual domain support
Single domain
support
Disk enclosure
supported
Supported in
StoreEasy
systems
Controller
model
YYD20001450, 1550, 1650,
1650E, 1850
P441
YYD3000
1. Smart Array controllers included as standard with StoreEasy 1x50 products do not support external disk enclosures.
An optional Smart Array controller with external ports need to be ordered to support external enclosures.
36 Installing HPE StoreEasy 1000 Storage
To Next Page
Loading...
