Error codes
This section contains the error codes that may occur.
Storage Management Provider error codes
The Storage Management Provider error codes are listed in Table 8 (page 159).
Table 8 Storage Management Provider errors
Recommended actionError messageError code
Restart Storage Management Service.Error during discovery.0x24005001
Restart Storage Management Service.Error while parsing CLI output.0x24005003
Restart Storage Management Service.Error while parsing CLI output.0x20005003
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
The controller specified was not found.0x25005008
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache
The specified RAID level is invalid.0x20005009
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
The specified RAID level is invalid.0x25005009
Retry the operation.The operation is not supported because the
storage pool is unhealthy.
0x2300500B
Retry the operation.The operation is not supported because the
storage pool is transforming.
0x2300500C
Retry the operation.The physical drive specified is already in use.0x2300500D
Retry the operation.Less than the minimum number of physical drives
was specified.
0x2300500E
Retry the operation.The specified physical drives are unsupported for
this operation. They may either be in use or are
a mismatch.
0x2300500F
Restart Storage Management Service.The physical disk was not found in the provider
cache.
0x24005011
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
The physical disk was not found in the provider
cache.
0x25005011
Restart Storage Management Service.No physical disks were found in the logical drive.0x24005012
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Failed to update pool in cache.0x25005013
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Failed to get the pool from the controller.0x25005014
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Failed to delete the pool from cache.0x25005015
Update the storage management provider cache by
invoking Windows PowerShell command
Update-StorageProviderCache.
Failed to get the pool IDs for the subsystem from
the controller.
0x25005016
Error codes 159
To Next Page
Loading...
