HP StoreEasy 1000

Flashing amber = System degraded
Flashing red (1 Hz/cycle per sec) = System critical
1
Solid green = System onPower On/Standby button and system
power LED
2
9
Flashing green (1 Hz/cycle per sec) = Performing power on
sequence
Solid amber = System in standby
Off = No power present
3
1
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health
status.
2
When all three LEDs described in this table and the UID button/LED on the rear panel flash simultaneously, a power
fault has occurred.
3
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the power button cable is disconnected.
StoreEasy 1650 Storage hardware components
The section illustrates the components and LEDs located on the front and rear panels of the
StoreEasy 1650 Storage.
Figure 7 StoreEasy 1650 Storage front panel components
2
1
2. Power LED1. LFF drives
12 HPE StoreEasy 1000 Storage