Table 77 TCP/UDP ports used for normal SAN operations with SAN/iQ (continued)
DescriptionNamePort(s)IP Protocol
Used for Virtual Manager
communication
SAN/iQ Internal13847TCP
Used for internal data
distribution and
resynchronization.
SAN/iQ Internal13848TCP
iSCSI initiators connect to
this port when using the HP
iSCSI13849TCP
LeftHand DSM for Microsoft
MPIO.
Used for HTTP requests to
the CIM gateway. Outgoing
CIM Server2003, 5988, 5989TCP, HTTP/HTTPS
from management
applications. Incoming to
storage systems. Used for
management control. Ports
used for Performance
Dashboard, Global Config
request to Mgmt Gateway.
Ports for CMC notifications
for Alarms Events from Mgmt
Gateway.
CIM13990 - 13999TCP
Used for heart-beating and
distributing configuration
SAN/iQ Database13891, 13893
NOTE: Port 13893 is UDP
only.
TCP, UDP
changes between
management nodes.
Used for internal control
communication.
SAN/iQ Control13888, 13889
NOTE: Port 13889 is UDP
only.
TCP, UDP
Used as iSCSI targets where
xx is the number of initiators
SAN/iQ Internal14000 – 140xxUDP
Communication to and from
the Failover Manager, when
applicable.
Failover Manager13887, 13892TCP
Communication to and from
the Failover Manager, when
applicable.
Failover Manager13947UDP
Used by the SAN/iQ
Diagnostic tool -DiagiQ that
SAN/iQ Diagnostics4443TCP
is run by HP LeftHand
Support to get advanced
diagnostics information
using a web interface.
Used by HP System Insight
Manager to display
HP System Insight Manager2301, 2302, 2381, 2382TCP
configuration information of
HP platforms like DL380 and
DL320s using a web
interface.
Ports used for connecting to
the CLI.
16022SSH
Incoming to storage systems.
Used for upgrading the
SAN/iQ Upgrade11120TCP
storage systems. Not
256 SAN/iQ TCP and UDP port usage
To Next Page
Loading...
