Figure 35 Searching for the unbonded storage system on the network
5. Search for the storage system by Host Name or IP Address or Subnet/Mask.
NOTE: Because it can take a few minutes for the storage system to set the network address,
the search may fail the first time. If the search fails, wait a minute or two and select Try Again
on the Network Search Failed message.
You can also use the Configuration Interface to delete a NIC bond. See “Deleting a NIC
bond” (page 241).
Verify NIC settings and communication settings after deleting a bond
1. Select a storage system, and open the tree below it.
2. Select Network.
3. Check the interfaces on the TCP/IP tab, and reconfigure them if necessary.
After deleting a bond, the interfaces may not have the correct IP addresses, or one interface
may be disabled.
4. Click the Communication tab.
66 Managing the network
To Next Page
Loading...
